Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
280 [2007/04/19 02:47] n5na |
280 [2007/05/21 00:41] (current) |
||
---|---|---|---|
Line 4: | Line 4: | ||
===== Description ===== | ===== Description ===== | ||
Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. | Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. | ||
+ | |||
===== Specifications ===== | ===== Specifications ===== | ||
- | ***Input:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz | + | ***Input Voltage:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz |
***Output:** 13.5 VDC +/- 0.5 VDC. | ***Output:** 13.5 VDC +/- 0.5 VDC. | ||
***Regulation:** Better than 1% no load to full load at 117 VAC. | ***Regulation:** Better than 1% no load to full load at 117 VAC. | ||
- | ***Output Current:** 20 ampere, full load. | + | ***Output Current:** 18 amperes, full load; 20 amperes, maximum. |
***Ripple:** Less than 60 mV peak-to-peak at 18A at 117 VAC. | ***Ripple:** Less than 60 mV peak-to-peak at 18A at 117 VAC. | ||
***Circuit Breaker:** Electronic latching. Factory set at 20A. | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
***Over-Voltage Protection:** Trips above 16V output. | ***Over-Voltage Protection:** Trips above 16V output. | ||
- | ***Connectors:** One 4-pin AMP MATE-N-LOC, two phono jacks for low current. | + | ***Panel Meter:** 0 - 25 amperes. |
+ | ***Connections:** Attached 3' cable with four pin AMP MATE-N-LOC connector for high current and remote on/off switching. Two phono connectors for low current output. | ||
+ | ***Finish:** Dark painted front panel, dark textured top and sides. | ||
***Size:** HWD 5.5" x 7" x 12". | ***Size:** HWD 5.5" x 7" x 12". | ||
***Wt:** 15 lbs. | ***Wt:** 15 lbs. |