Differences
This shows you the differences between two versions of the page.
280 [2007/04/19 02:51] n5na |
280 [2007/05/21 00:41] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Power Supply Model 280 ====== | ||
- | {{280.jpg?150|}} | ||
- | ===== Description ===== | ||
- | Ideal for powering the CORSAIR Model [[560]] transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model [[255]], but with dual primary and without the build-in speaker. | ||
- | |||
- | |||
- | ===== Specifications ===== | ||
- | |||
- | ***Input Voltage:** 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz | ||
- | ***Output:** 13.5 VDC +/- 0.5 VDC. | ||
- | ***Regulation:** Better than 1% no load to full load at 117 VAC. | ||
- | ***Output Current:** 18 amperes, full load; 20 amperes, maximum. | ||
- | ***Ripple:** Less than 60 mV peak-to-peak at 18A at 117 VAC. | ||
- | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
- | ***Over-Voltage Protection:** Trips above 16V output. | ||
- | ***Panel Meter:** 0 - 25 amperes. | ||
- | ***Connections:** Attached 3' cable with four pin AMP MATE-N-LOC connector for high current and remote on/off switching. Two phono connectors for low current output. | ||
- | ***Finish:** Dark painted front panel, dark textured top and sides. | ||
- | ***Size:** HWD 5.5" x 7" x 12". | ||
- | ***Wt:** 15 lbs. |