Differences
This shows you the differences between two versions of the page.
262m [2007/04/17 21:54] n5na |
262m [2007/05/21 00:41] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== AC Power Supply Model 262M ====== | ||
- | {{262m.jpg?150|}} | ||
- | ===== Description ===== | ||
- | For use with Models [[540]] and [[544]]. Fully voltage regulated to provide highly stable, pure DC (225 watts) from 117 VAC. Panel DC ammeter. Instantaneous overload protection circuit prevents damage caused by excessive current drain; reset by momentary turn-off. Includes a complete VOX system. VOX controls are located on front panel. Low frequency components invoice below cut-off frequency of speaker actuate T/R function. | ||
- | |||
- | ===== Specifications ===== | ||
- | ***Input Voltage:** 117 VAC, 50-60 Hz | ||
- | ***Output Voltage:** 13 VDC +/- 0.5 V | ||
- | ***Regulation:** Better than 1% no load to full load @ 117 VAC | ||
- | ***Output Current:** Zero to 18 A, built-in ammeter | ||
- | ***Ripple:** Less than 60 mV p-p @ 18 A and 117 VAC | ||
- | ***Circuit Breaker:** Trips at 20 A (manual reset) | ||
- | ***Output Connections:** One 4-pin AMP MATE-N-LOK type. Two Phono Jacks for low current. | ||
- | ***Finish:** Satin aluminum front panel, black pebble-grain sides and top. | ||
- | ***Semiconductors:** 4 transistors, 1 SCR, 7 diodes | ||
- | ***Size:** HWD 4.5" x 8.25" x 13" | ||
- | ***Weight:** 15 lbs | ||
- | |||
- | ===== VOX Specifications ===== | ||
- | ***Mic Input Impedance:** Greater than 3 megohms for crystal, ceramic, or hi-Z dynamic microphones | ||
- | ***Transmitter Microphone Channel Gain:** Unity | ||
- | ***Maximum Microphone Input Level:** 250 mV, rms | ||
- | ***VOX Sensitivity:** Less than 1 mV @ 200 Hz trips T/R | ||
- | ***Delay:** Adjustable from 0.1 to 1 sec. | ||
- | ***Semiconductors:** 1 IC, 10 transistors, 3 diodes |