Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
2591oper [2007/04/07 16:11]
n5na created
2591oper [2007/05/20 20:41] (current)
Line 20: Line 20:
     *Start a program scan:  After you have a freq range and step set up, push F then MS to access the secondary function PS (program scan)     *Start a program scan:  After you have a freq range and step set up, push F then MS to access the secondary function PS (program scan)
     *Stop a scan:  Keying the HT stops any scan.     *Stop a scan:  Keying the HT stops any scan.
-    *You can also run the frequency up or down by using the up or down arrow keys.**+    *You can also run the frequency up or down by using the up or down arrow keys.
     *The Hold/Skip (Tone) switch works when you scan.  Hold pauses the scan until the carrier drops. ​ Skip lets the scan continue after a few seconds. ​ Tone was intended to be used to turn an internal PL on and off, but that never happened.     *The Hold/Skip (Tone) switch works when you scan.  Hold pauses the scan until the carrier drops. ​ Skip lets the scan continue after a few seconds. ​ Tone was intended to be used to turn an internal PL on and off, but that never happened.
  

QR Code
QR Code 2591oper (generated for current page)