Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
2591oper [2007/04/07 20:11] n5na created |
2591oper [2007/05/21 00:41] (current) |
||
---|---|---|---|
Line 20: | Line 20: | ||
*Start a program scan: After you have a freq range and step set up, push F then MS to access the secondary function PS (program scan) | *Start a program scan: After you have a freq range and step set up, push F then MS to access the secondary function PS (program scan) | ||
*Stop a scan: Keying the HT stops any scan. | *Stop a scan: Keying the HT stops any scan. | ||
- | *You can also run the frequency up or down by using the up or down arrow keys.** | + | *You can also run the frequency up or down by using the up or down arrow keys. |
*The Hold/Skip (Tone) switch works when you scan. Hold pauses the scan until the carrier drops. Skip lets the scan continue after a few seconds. Tone was intended to be used to turn an internal PL on and off, but that never happened. | *The Hold/Skip (Tone) switch works when you scan. Hold pauses the scan until the carrier drops. Skip lets the scan continue after a few seconds. Tone was intended to be used to turn an internal PL on and off, but that never happened. | ||