Power Supply / Speaker Model 255

Description

Designed to match the OMNI Models 545 and 546 transceivers. Deluxe power supply with metered output, high current, and built-in speaker. Integral overload current protection circuit is activated when more than 20 amperes are drawn from the supply. The electronic circuit breaker is latching type, requiring manual reset. Over-voltage protection is integral. Primary power is switched from the front panel or remotely from the transceiver.

Mods & Tips

Specifications

  • Input Voltage: 105 - 125 VAC, 50-60 Hz
  • Output Voltage: 13.5 VDC +/- 0.5 V
  • Regulation: Better than 1% no load to full load @ 117 VAC
  • Output Current: Zero to 18 amperes, full load, 20 amperes maximum.
  • Ripple: Less than 60 mV p-p @ 18 A and 117 VAC
  • Circuit Breaker: Electronic latching. Factory set at 20A.
  • Over-voltage Protection: Trips above 16V output.
  • Panel Meter: 0 - 25 amperes.
  • Speaker: 3" x 5" oval, 8 ohm, ceramic magnet.
  • Output Connectors: Attached 3' cable with four pin AMP MATE-N-LOK connector for high current and remote on/off switching. Two phono connectors for low current. Attached 3' cable with 1/4" phone plug for speaker input. Front panel PHONES jack.
  • Finish: Satin etched and extruded panel trim, dark painted front panel, dark textured top and bottom.
  • Size: HWD 5-7/8" x 8-1/4" x 12".
  • Weight: 16 lbs.

QR Code
QR Code 255 (generated for current page)