Differences
This shows you the differences between two versions of the page.
255 [2007/04/18 01:40] n5na |
255 [2007/05/21 00:41] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Power Supply / Speaker Model 255 ====== | ||
- | {{255.jpg?150|}} | ||
- | ===== Description ===== | ||
- | Designed to match the OMNI Models 545 and 546 transceivers. Deluxe power supply with metered output, high current, and built-in speaker. Integral overload current protection circuit is activated when more than 20 amperes are drawn from the supply. The electronic circuit breaker is latching type, requiring manual reset. Over-voltage protection is integral. Primary power is switched from the front panel or remotely from the transceiver. | ||
- | |||
- | ===== Specifications ===== | ||
- | |||
- | ***Input Voltage:** 105 - 125 VAC, 50-60 Hz | ||
- | ***Output Voltage:** 13.5 VDC +/- 0.5 V | ||
- | ***Regulation:** Better than 1% no load to full load @ 117 VAC | ||
- | ***Output Current:** Zero to 18 amperes, full load, 20 amperes maximum. | ||
- | ***Ripple:** Less than 60 mV p-p @ 18 A and 117 VAC | ||
- | ***Circuit Breaker:** Electronic latching. Factory set at 20A. | ||
- | ***Over-voltage Protection:** Trips above 16V output. | ||
- | ***Panel Meter:** 0 - 25 amperes. | ||
- | ***Speaker:** 3" x 5" oval, 8 ohm, ceramic magnet. | ||
- | ***Output Connectors:** Attached 3' cable with four pin AMP MATE-N-LOK connector for high current and remote on/off switching. Two phono connectors for low current. Attached 3' cable with 1/4" phone plug for speaker input. Front panel PHONES jack. | ||
- | ***Finish:** Satin etched and extruded panel trim, dark painted front panel, dark textured top and bottom. | ||
- | ***Size:** HWD 5-7/8" x 8-1/4" x 12". | ||
- | ***Weight:** 16 lbs. |