Power Supply Model 280

Ideal for powering the CORSAIR Model 560 transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model 255, but with dual primary and without the build-in speaker.

• Input Voltage: 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz
• Output: 13.5 VDC +/- 0.5 VDC.
• Regulation: Better than 1% no load to full load at 117 VAC.
• Output Current: 18 amperes, full load; 20 amperes, maximum.
• Ripple: Less than 60 mV peak-to-peak at 18A at 117 VAC.
• Circuit Breaker: Electronic latching. Factory set at 20A.
• Over-Voltage Protection: Trips above 16V output.
• Panel Meter: 0 - 25 amperes.
• Connections: Attached 3' cable with four pin AMP MATE-N-LOC connector for high current and remote on/off switching. Two phono connectors for low current output.
• Finish: Dark painted front panel, dark textured top and sides.
• Size: HWD 5.5" x 7" x 12".
• Wt: 15 lbs.