Power Supply / Speaker Model 255

Designed to match the OMNI Models 545 and 546 transceivers. Deluxe power supply with metered output, high current, and built-in speaker. Integral overload current protection circuit is activated when more than 20 amperes are drawn from the supply. The electronic circuit breaker is latching type, requiring manual reset. Over-voltage protection is integral. Primary power is switched from the front panel or remotely from the transceiver.

• Cure for Physical Hum

• Input Voltage: 105 - 125 VAC, 50-60 Hz
• Output Voltage: 13.5 VDC +/- 0.5 V
• Regulation: Better than 1% no load to full load @ 117 VAC
• Output Current: Zero to 18 amperes, full load, 20 amperes maximum.
• Ripple: Less than 60 mV p-p @ 18 A and 117 VAC
• Circuit Breaker: Electronic latching. Factory set at 20A.
• Over-voltage Protection: Trips above 16V output.
• Panel Meter: 0 - 25 amperes.
• Speaker: 3" x 5" oval, 8 ohm, ceramic magnet.
• Output Connectors: Attached 3' cable with four pin AMP MATE-N-LOK connector for high current and remote on/off switching. Two phono connectors for low current. Attached 3' cable with 1/4" phone plug for speaker input. Front panel PHONES jack.
• Finish: Satin etched and extruded panel trim, dark painted front panel, dark textured top and bottom.
• Size: HWD 5-7/8" x 8-1/4" x 12".
• Weight: 16 lbs.