====== Triton IV Model 540 ======
{{540.jpg?150}}
===== Description =====
Solid state transceiver covering 3.5 to 30 Mhz with 200 watts //input// on all bands.
===== Accessories =====
*Digital Readout Model [[244]]
*One-Sixty Converter Model [[240]]
*Remote VFO Model [[242]]
*Crystal Oscillator Model [[241]]
*Microphone & Stand Model [[215]]P
*AC Power Supply Model [[262M]]
*AC Power Supply Model [[252M]]
*Antenna Tuner Model [[247]]
*Noise Blanker Model [[249]]
*CW Filter Model [[245]]
*Additional Crystals Models [[212]] and [[213]]
*Mobile Circuit Breaker Model [[1140]]
===== Reviews =====
*[[http://www.eham.net/reviews/detail/736|eHam]]
===== Mods & Tips =====
*[[544keyloop|Add QSK Amp Loop Mod]]
*[[tritonpwr|Triton Power Connector]]
*{{triton_iv_service_note_sn-1-540.pdf|Triton VI Service Note SN-1-540}} - Using Accessories with the Triton IV
*[[http://p1k.arrl.org/pubs_archive/74970|Add A Crystal Filter To Your Ten-Tec 540!]] (QST Archive - Must be an ARRL member to access.)
===== Sales Information =====
*{{540_544brochure.pdf|Triton IV Sales Brochure}} (1.2 MB)
===== Specifications =====
==== General ====
***Frequency Bands:** 3.5 - 4.0, 7.0 - 7.5, 14.0 - 14.5, 21.0 - 21.5, 28.0 - 28.5, 28.5 - 29.0, 29.0 - 29.5, 29.5 - 30.0 MHz. Ten meter crystals furnished for 28.0 - 29.0 MHz.
***All circuits permeability tuned.**
***Tuning Rate:** Tuning vernier 25 kHz per revolution, typical.
***Direct frequency readout:** Slide rule, color coded dial indicates 100 kHz segment, dial skirt increment to 1 kHz. Accuracy +/- 1 kHz from nearest 25 kHz calibration point.
***Calibrator:** 25 Khz pulsed calibrator
***Automatic sideband selection, reversible**
***VFO Frequency Stability:** Less than 15 Hz change per Fo, averaged over a 40o change from 70o to 110o, after 30 minute warmup. Less than 10 Hz change from 105 to 125 VAC line voltage when using TEN-TEC power supply.
***Power Required:** 12-14 VDC, 500 mA receive, 18 A maximum transmit.
***Modular Contruction:** 10 plug-in assemblies and 7 fixed circuit boards.
***Semiconductors:** 47 transistors, 33 diodes, 11 IC's
***Power switch remotely controls power supply.**
***Snap-up front feet.**
***Contruction:** Rigid aluminum chassis, sub-panels, top and bottom. Cycolac plastic side panels.
***Finish:** Etched aluminum panel, textured black top and sides
***Dimensions:** HWD 4.5" x 13.625" x 13"
***Weight:** 12 lbs.
==== Receiver ====
***Mosfet RF Amplifier**
***Preselector Resonate Control**
***Sensitivity:** 0.3 uV for 10 dB S+N/N.
***Filtering:** 2.6 kHz bandwidth, 1.8 shape factor at 6/60 dB points. Optional CW Filter - 150 Hz wide, two positions, shape factor 7.2 at 6/60 dB.
***AGC Controlled by RF Gain Control**
***Meter Automatically Switched to "S" meter when receiving**
***Offset Tuning with Defeat Switch and LED Indicator**
***Built-in Speaker in Bottom**
***External Speaker/Phone Jack**
***Less than 2% Audio Distortion**
***WWV Reception at 10 and 15 MHz**
==== Transmitter ====
***200 Watts Input, SSB and CW, 100% Duty Cycle**
***Instant Band Change, No Tune-up Required**
***8-Pole SSB Filter**
***Automatic Level Control on Front Panel, LED Indicator Shows Operation in ALC Region**
***CW Sidetone Fed into Audio Amplifier when in CW Mode**
***Sidetone Adjustable for Tone and Volume**
***Automatic CW Offset of 750 Hz**
***Press-To-Talk**
***Meter Indicates SWR When Transmitting**
***High Impedance Microphone Input**
***RF Output Impedance 50 - 75 ohms, unbalanced.**